Osprey Cam: Back up and running!
After much delay…
by Ben Wurst, Habitat Program Manager
Last week we set out to finally repair the osprey cam at Edwin B. Forsythe NWR. (Note: we do all of the technical repairs and maintenance to the camera system) Initial repairs were delayed to protect the osprey young. Timing restrictions are set in place to reduce disturbance to nesting ospreys and nests cannot be disturbed from April 1 – August 30. This is a good thing! When we finally set out to figure out the issue with why the camera suddenly lost power, we had to wait until it was safe to enter the nest. When we first went out (August 15) for a quick diagnosis (after we knew all young were flying and not relying on the nest as much) and got the cam online again…but it died after 30 minutes of streaming…
We went out again in late September and determined it was the solar charge controller but had to wait to get a new one. In October we went out out to replace the charge controller but the system was still down and the equipment was not getting power. The two batteries only had 6 volts of charge and needed to be recharged. So, the two 50lb. batteries were lugged a pretty long distance and charged up. Once they held a charge we made plans to go back to re-install them and hoped it would work. Success!! The batteries powered up the system and within minutes the camera was streaming online!
Special thanks to volunteer Joe Bilotta for helping out with the re-installation of the batteries!
